Working platform Flück Holzbau AG, Wangen

The project
The new work platform of Flück Holzbau AG in Wangen near Dübendorf is 15 meters long, 7.5 meters wide, 36 centimeters thick, weighs 18 tons - and is largely made of wood. It is used to process the wooden elements from the newly installed TW-Agil 3000 joinery system, which has an inlet width of 3000 millimeters. The challenge The enormous spans combined with the high payloads posed a major challenge for the timber construction. The platform consists of three cross-laminated timber panels, which were glued together to form one large panel using TS3 technology. In order to relieve the adhesive tension side and to minimize deflection and vibrations, the panel was eccentrically prestressed with tie rods.

The construction
The height of the platform's girder, which is stretched over the entire 15 meters, was limited. The reason was that the feeder for the panel processing line was to be located on the lower side, while on the upper side the girder was not to protrude too high above the platform so that the forklift truck could transport the packages with the wood away. The girder height therefore had to be limited to 700 millimeters. For this reason, a high-performance beam made of laminated beech veneer lumber was used. However, the deformations became too high with this. For this reason, two steel tie rods were inserted in the girder in the shape of a fish belly and prestressed. On the one hand, this allowed the girder to be raised, and on the other hand it made the girder stiffer and reduced the deformation.